---
title: "Stick Drift Test – Check Your Controller for Drift Online"
description: "Test your controller for stick drift online. See how far each stick rests off centre, what deadzone hides it and how to fix it. Checks triggers and rumble."
url: https://devicetests.com/stick-drift-test
language: en
---

# Stick drift test

Check your controller for stick drift. See if a stick moves by itself, how much, and what to do about it.

> **Interactive test.** This test runs in the browser on the user's own device and uses that device's hardware, so an AI agent can't run it for the user. To use it, the user opens <https://devicetests.com/stick-drift-test> in a browser.
>
> **What it needs:** A game controller with analog sticks, connected to the device by USB or Bluetooth: Xbox, PlayStation, Nintendo or another gamepad. The user presses a button so the browser can see it, then puts the controller down and lets go of the sticks for 5 seconds, then turns each stick around its edge.
>
> **Cost:** Free. Nothing to install and no account.

This stick drift test needs JavaScript to read your controller. Turn on JavaScript, or open this page in a current Chrome, Edge, Firefox or Safari.

## Quick start

1. Connect your controller and press any button on it.
2. Move both sticks in a full circle. Let go, then press **Start drift test**.
3. Turn each stick round its edge until it says **Full circle**.
4. Press **Show my result** to see what the test found and what to do.

## How to read your results

| What you see | What it means |
| - | - |
| **Dots close to the middle** | The stick rests in the centre. That is normal. |
| **Dots outside the dashed ring** | The stick rests outside the deadzone. Games may move by themselves: stick drift. |
| **A round outline** | The stick reaches its edge in every direction. |
| **A dent in the outline** | The stick stops short in one direction. It may be worn or blocked. |

**Step 1, drift** shows the middle of each stick, magnified 4 times. The outer circle there is only 25% from the centre, so small drift is easy to see. The dashed ring is the deadzone. Each dot is one reading from the 5-second drift test. The ring with no fill shows where the stick rests.

| Rests off centre | What it means | What to do |
| - | - | - |
| Up to 5% | Normal. New controllers rest a few percent off centre too. | Nothing. |
| Over 5% and up to 15%, inside the deadzone | Games with this deadzone ignore it. | Nothing yet. Test again in a few weeks. |
| Outside the deadzone, up to 15% | Likely **mild** stick drift. A game with a slightly bigger deadzone hides it. | Calibrating or cleaning may help. Until then, set your game’s deadzone to the value the test shows. |
| Over 15%, up to 25%, even with a bigger game deadzone | Likely **moderate** drift: more than most games’ usual deadzones hide. A deadzone that big makes aiming less exact. | Calibrate or clean it, then think about the warranty or a repair. |
| Over 25% | Likely **severe** drift: only a very large deadzone hides it, and the stick loses much of its exact movement. | Calibrate or clean it, then repair or replace it. |

“Likely”, because the test sees what your browser gets: a thumb on the stick, a remapping app or a system setting can change the reading. Test twice before you decide: a point either way between tests is normal.

Under each stick you also see:

- **Leans:** which way the stick rests, for example “to the right”.
- **Most readings stayed within … of where it rests:** how much the stick moved during the test with nobody touching it. If it hardly moved, you see **It stayed still with hands off** instead. A steady stick usually stays within 1% to 2%; more than 3% can be dirt or wear. A stick that keeps moving with nobody touching it may be worn, even if it rests near the middle.
- **Before:** and **Now:** after a second drift test, both readings, so you can see if cleaning helped.

**Step 2, edge** draws the furthest each stick went in every direction. “Shortest reach” is the direction where it went least far. Under 90% means it doesn’t reach its edge there. Roundness is how far the outline is from a circle on average. Many controllers have square-ish corners that go past the circle: that is normal.

**Step 3, triggers** show how far each trigger is pressed now, the highest it reached and where it settles when you let go. A trigger should reach 90% or more and go back to 0%.

**Your result.** When both sticks are measured, the bar above the test says so and shows the **Show my result** button. Press it and the result takes the place of the test. Steps 2 to 4 are extra: to do them, press **Continue test**. Your readings are kept.

> **Tip:** Change the deadzone under step 1 to match your game. The words under each stick follow it.

## If something’s wrong

These steps go from the easiest to the most expensive. Test again after each one to see if it helped.

### A stick drifts

1. **Test again.** Move the stick round in big circles 20 times, put the controller down and press **Start drift test** again. Dust can make a stick stick for a moment.

2. **Calibrate it, if your system can.**

   - **Nintendo Switch:** open System Settings, then Controllers and Sensors, then Calibrate Control Sticks.
   - **Xbox Wireless and Elite Series 2 controllers:** open the Xbox Accessories app on an Xbox or a Windows computer, choose your controller and recalibrate its thumbsticks. The app can recalibrate the triggers too.
   - **Steam:** open Settings, then Controller, choose your controller and open its calibration settings. This only changes games you play through Steam.
   - **Other controllers on Windows:** search for “Set up USB game controllers”, choose your controller, then Properties. Some controllers have a Calibrate button there.
   - **PlayStation consoles** have no stick calibration.

3. **Clean round the stick.** Turn the controller off. Gently brush round the base of the stick with a clean, dry toothbrush, as Nintendo advises. Wipe the outside with a soft, dry cloth. Never pour or spray liquid into a controller.

4. **Raise the deadzone in your game.** Set the stick deadzone to the value the test shows under the stick. Some games write 15% as 0.15. If your game shows no numbers, raise it a step at a time until the movement stops. This hides the drift but doesn’t fix it, and the stick feels a little less exact.

5. **Update the controller.** Xbox controllers update in the Xbox Accessories app. PlayStation controllers update on the console, or in the PlayStation Accessories app on a Windows computer.

6. **Use the warranty or a repair service.** If your controller is under warranty, contact the maker or the shop. Nintendo repairs drifting Joy-Con in many countries, even after the warranty: check Nintendo support for your country. Download or print your result to show the reading.

7. **Replace the stick or the controller.** A repair shop can replace the stick. A controller with Hall effect or TMR sticks doesn’t wear out in the same way.

Each fix is explained step by step in [Stick drift: what causes it and how to fix it](https://devicetests.com/stick-drift).

**What a browser can’t fix:** this test only reads your controller. It can’t calibrate it, change your game’s deadzone or repair it.

### A stick doesn’t reach its edge

Turn it slowly round its edge again, pushing all the way out. If one direction stays under 90%, check for dirt or a damaged rubber cap round the stick. A worn stick can also stop short. Most games still work, but full speed in that direction may be hard to reach.

### A trigger doesn’t go all the way, or doesn’t spring back

Press it all the way down. If **Highest** stays under 90%, check for a trigger stop switch on the back of the controller. If **At rest** stays above 5% after you let go, the trigger is dirty or its spring is worn. Nintendo controllers have triggers that are only on or off: they jump to 100%.

### A motor doesn’t vibrate

Check that vibration is turned on in your system settings and in the controller’s app. Vibration works best in Chrome and Edge on a computer. It doesn’t work in Firefox. On phones and tablets, it depends on the browser and the controller. On Windows, some PlayStation controllers only vibrate with a USB cable. Trigger motors show only where the browser can use them: Chrome or Edge on Windows or a Mac with an Xbox controller. On Linux and Chromebooks, they work only over Bluetooth.

### The test can’t find the sticks

Some controllers don’t use the standard layout, so the browser doesn’t say which numbers are the sticks. Try Chrome or Edge, switch the controller to its Xbox (X-input) mode if it has one, or open the [controller tester](https://devicetests.com/controller-tester) to see every button and axis by number.

### Nothing happens when you connect the controller

Press a button on it: browsers only show a controller after a button press. Privacy settings or extensions can hide controllers from web pages, for example Firefox’s “resist fingerprinting”. Try another browser. The [controller tester](https://devicetests.com/controller-tester) has pairing steps for each controller and more fixes.

## How this test works

Your browser reads the controller about as often as your screen updates, while this page is open in front. It gives each stick as two numbers from −1 to 1, before any game applies its deadzone. The test shows the numbers as the browser gets them: it never subtracts a resting offset or hides small values, because that would hide drift. Your system or the controller itself may already have adjusted them.

Chrome and Edge show each stick axis as 0 until it has once read near the middle, so a stick that drifts more than 10% can read exactly 0 until you move it. If a stick has only ever read exactly 0, the test doesn’t judge it and asks you to move it in a full circle.

**Start drift test** collects every reading for 5 seconds while you don’t touch the controller. The resting offset is the distance from the centre that 95% of the readings stay within. If a stick moves more than 5% during the test, the test asks you to try again. If it moves again, it measures the stick as it is and says it kept moving. Without the test, the page also reads a stick that stays still near the middle for 1 second.

The edge is measured in 36 directions, 10 degrees each. Each direction keeps the furthest the stick went.

Your readings stay in your browser: the test doesn’t upload them.

See [how we test controllers](https://devicetests.com/how-we-test#keyboards-mice-and-controllers) for where our limits come from, and what a browser can’t measure.

**What the test can’t see**

- The deadzone your system, browser or game adds. iPhone and iPad add their own, and browsers can adjust Nintendo controllers, so small drift can read 0% there.
- Changes made by apps such as Steam Input or DS4Windows before the browser gets the stick.
- Controllers without the standard layout, and one Joy-Con on its own.
- How fast your controller reports, or input lag.

[How we test our tools](https://devicetests.com/how-we-test)

## Questions and answers

**How much stick drift is normal?**

Every stick rests a little off centre, even a new one. Up to 5% is normal. Games ignore a stick inside their deadzone, which is often 10% to 15%. A stick that rests further out than your game's deadzone moves things by itself. This test calls it mild drift up to 15%, moderate up to 25% and severe above that.

**Why does my new controller show 2 or 3%?**

That is normal. Sticks are not perfectly centred, and every controller sends small numbers when you let go. Games use a deadzone so you never notice it.

**Can this website fix stick drift?**

No. A website can only read what your controller sends. It can't calibrate the controller, change your game's settings or repair the stick. The steps under **If something's wrong** show what you can do.

**Does cleaning fix stick drift?**

Sometimes, for a while. Dust round the base of the stick can cause small drift. If the part inside the stick is worn, cleaning won't fix it for long. Test again after cleaning to see if it helped.

**Is stick drift covered by the warranty?**

Usually, if the controller is still under warranty. Nintendo repairs drifting Joy-Con in many countries, even after the warranty. Download or print your result to show how far the stick rests off centre.

**Do Hall effect sticks drift?**

Hall effect and TMR sticks use magnets instead of parts that rub together, so they don't wear out in the same way. They can still rest a little off centre, so test them the same way.

**Why does a stick show exactly 0% until I move it?**

Chrome and Edge show each stick as 0 until it has once been near the middle, even when it drifts, so a stick drifting more than 10% can read 0% at first. Move both sticks in a full circle before the drift test. Some systems also add a small deadzone that shows a resting stick as 0%.

**Why does my iPhone or iPad show 0% when the stick drifts a little?**

iPhone and iPad add their own small deadzone before the browser gets the stick. Very small drift can show as 0% there. Test on a computer to see it.

**Can I test a Joy-Con?**

Yes. Pair both Joy-Con with your computer by Bluetooth. Chrome joins them into one controller, so you can test both sticks. One Joy-Con on its own shows only numbered buttons, so this test can't find its stick.

## Related tests

- [Controller tester](https://devicetests.com/controller-tester): Check the buttons and sticks on your game controller.
- [Keyboard tester](https://devicetests.com/keyboard-tester): Check that every key on your keyboard works.
- [Mouse test](https://devicetests.com/mouse-test): Check your mouse buttons, scroll wheel and double-click.
- [PS5 controller test](https://devicetests.com/ps5-controller-test): Check every button, trigger and stick on a PS5 DualSense controller.
- [Xbox controller test](https://devicetests.com/xbox-controller-test): Check every button, stick and trigger motor on an Xbox controller.

Buying a new controller? [Controller finder](https://devicetests.com/controller-finder)
