Cello tuner

Bow or pluck a string and see if it is too low or too high. Made for the cello's C, G, D and A.

The sound stays on your device. We don't record or upload it.

Your browser will ask to use your microphone. Choose Allow.

Hear a string: press it to play its note

Quick start

  1. Press Start tuner, then choose Allow.
  2. Bow the A string first, with a long, steady bow.
  3. Turn its fine tuner or peg until the tuner says In tune.

How to read the tuner

The large letter is the string you are playing, such as A3 for the A string. The number after the letter is the octave. Under it you see the string number.

What you see What it means What to do
Too low. Tighten the string a little. Needle left of the middle. The string sounds lower (flat) than its note. Turn the fine tuner clockwise, a little at a time.
Too high. Loosen the string a little. Needle right of the middle. The string sounds higher (sharp) than its note. Turn the fine tuner anticlockwise, a little at a time.
In tune with a check mark. Needle in the middle. Within 5 cents of the note. Go to the next string. Its button keeps a check, so you can see which strings are done.
Much too low or Much too high More than half a semitone off. Use the peg, not the fine tuner. Check the string number first.
Not an open string The note is far from every string. Play the string without a finger on it.

The small figures show the exact pitch in hertz (Hz, vibrations per second) and how many cents it is off. A cent is a hundredth of a semitone.

The notes of the cello

Strings are listed from the lowest (the thickest) to the highest. The highest string is string 1.

String 4 String 3 String 2 String 1
C2 (65.4 Hz) G2 (98.0 Hz) D3 (146.8 Hz) A3 (220 Hz)

Each string is a fifth (7 semitones) above the one before it. The cello has the same notes as the viola, one octave lower.

Tip: To remember the strings, say “Cats Go Down Alleys” (C G D A), from the lowest string to the highest.

How to tune a cello

  1. Sit and get ready. Pull out the endpin and lock its screw, so the cello stays still while you turn the pegs.
  2. Tune the A first. It is the note an orchestra tunes to. Then tune D, G and C.
  3. Small changes: fine tuners. These are the screws on the tailpiece. Turned clockwise, seen from above, they make the note higher.
  4. Bigger changes: the pegs. Turn the peg slowly, and push it gently into the pegbox as you turn. The push keeps it from slipping back.
  5. Check the bridge. Tuning pulls the top of the bridge towards the fingerboard. Look from the side: the bridge should stand straight up from the top of the cello.
  6. Check all strings again. Each string you tighten changes the others a little.

If something’s wrong

The low C string doesn’t work, or jumps around

The C string vibrates only 65 times a second. Small phone and laptop microphones are made for voices and hear such low notes weakly. The tuner can then hear mostly the C an octave higher. It still shows that as string 4, the C.

  1. Move the phone closer, about 20 cm (8 inches) from the f-holes.
  2. Bow a full, steady note with a little more weight. Let it ring.
  3. Check the string number before you turn the peg. String 4 is the C.
  4. Still no luck? Press the C string button and tune by ear. Or play the open G and C together, and tune C until the sound is smooth.

A peg slips back, or won’t turn

  1. It slips: push the peg firmly into its hole while you turn it. Pegs slip more in dry air, when the wood shrinks.
  2. It sticks or jumps: turn it back a little, then forward slowly. Pegs stick more in damp air.
  3. If it keeps slipping or sticking, ask a string shop. They can add peg paste, or fit the peg again.

The fine tuner won’t turn any further

  1. It is screwed all the way in. Look underneath: it can scratch the top of the cello.
  2. Turn the fine tuner back to the middle of its range.
  3. Tune the string with its peg, then finish with the fine tuner.

One note howls or stutters

That is a wolf tone: one note that matches the body’s own ringing. On most cellos it lies somewhere between E3 and G3. It doesn’t change the open strings, so tune as usual. A wolf eliminator (a small weight on a string behind the bridge) can soften it.

The tuner doesn’t react when I play

  1. Check that the hint under the tuner doesn’t say the microphone is paused.
  2. Bow a little more firmly, and move the phone closer.
  3. Make sure the browser listens to the right microphone. Unplug a headset you don’t use.
  4. Try the microphone test. If it hears nothing either, the problem is the microphone.

The note jumps around

  1. Use long, steady bows on one string at a time. Don’t let the next string ring.
  2. Rosin the bow if the sound is thin or scratchy.
  3. Keep other sounds down: talking, music or other players.

I can’t hear the string’s note

  1. Turn up your device’s volume. Phone speakers play the low C quietly, so headphones help.
  2. On iPhone or iPad, turn off Silent mode.
  3. While the tuner listens, an iPhone can play the note quietly. Press Stop tuner, then press the string again.

My browser blocked the microphone

The tuner shows how to allow it for your browser, with a Try again button. You can still tune by ear: press a string to hear its note.

How the cello tuner works

The tuner listens to your microphone inside your browser. It looks for the time after which the sound repeats itself: that is one vibration of the string. The method is called YIN, and it is used by many tuners and music apps. It finds that time even when the microphone hears the lowest note weakly.

  • Readings: about 25 a second. The tuner shows the middle value of the last 5, so one stray reading never moves the needle.
  • Accuracy: on a clear, steady note the reading is steady to about 1 cent. A noisy room, a scratchy bow or a far-away phone make it wobble by a few cents.
  • Range: it listens from F1 (44 Hz) to B4 (494 Hz), so higher sounds don’t fool it.
  • The browser’s clean-up is off: noise suppression, echo cancellation and automatic volume would treat a long bowed note as noise.
  • Limits: the tuner checks the open strings only. It can’t tell whether your fingers are in tune. For other tunings, such as Bach’s fifth suite with the A string down to G, use the online tuner.

Questions and answers

Does it work on a phone?

Yes. It works in the browser on iPhone, iPad and Android phones. Put the phone on a music stand or chair, about 30 cm (a foot) from the f-holes.

Phone microphones hear the low C string less well. Bow it firmly and let it ring. The section on the low C above has more help.

Should I use the pegs or the fine tuners?

Use the fine tuners when a string is only a little off. Use the peg when a string is far off, or when its fine tuner is screwed all the way in. Some cellos have a fine tuner only on the A string. Then tune the other strings with their pegs.

The orchestra plays an A. Why does my A string sound lower?

The orchestra's A is A4, 440 Hz. The cello's A string is A3, 220 Hz, one octave lower. Both are an A, so they match. If your orchestra tunes to 442, set Pitch of A4 to 442 Hz, and your A string becomes 221 Hz.

What are cents?

A cent is a hundredth of a semitone, the step between two neighbouring notes. The tuner says how many cents a string is too low (−) or too high (+). Within 5 cents counts as in tune, which is closer than most ears can hear.

I tuned my C by ear and the tuner says it is low. Why?

Cellists often tune each pair of strings until they sound smooth together, a "pure" fifth. That fifth is 2 cents wider than a tuner's. Three fifths down from the A, the C ends up about 6 cents low. That is fine for playing alone. Next to a piano, tune the C to the tuner.

Can I tune by ear instead?

Yes. Press a string's button to hear its note, then tune the string until both sound the same. When they are close, you hear a slow wobble. Tune until the wobble stops. Press the button again to stop the note.

Is my playing recorded or uploaded?

No. The tuner measures the sound inside your browser, on your device. Nothing is recorded, kept or sent anywhere.