Violin tuner
Bow or pluck a string and see if it is too low or too high. For violin and viola.
The sound stays on your device. We don't record or upload it.
Hear a string: press it to play its note
Quick start
- Press Start tuner, then choose Allow.
- Bow or pluck the A string first, and let it ring.
- Turn its fine tuner or peg until the tuner says In tune.
How to read the tuner
The large letter is the string you are playing, such as A4 for the A string. The number after the letter is the octave. Under it you see the string number.
| What you see | What it means | What to do |
|---|---|---|
| Too low. Tighten the string a little. Needle left of the middle. | The string sounds lower (flat) than its note. | Turn the fine tuner clockwise, a little at a time. |
| Too high. Loosen the string a little. Needle right of the middle. | The string sounds higher (sharp) than its note. | Turn the fine tuner anticlockwise, a little at a time. |
| In tune with a check mark. Needle in the middle. | Within 5 cents of the note. | Go to the next string. Its button keeps a check, so you can see which strings are done. |
| Much too low or Much too high | More than half a semitone off. | Use the peg, not the fine tuner. Check the string number first. |
| Not an open string | The note is far from every string. | Play the string without a finger on it. Check the Instrument. |
The small figures show the exact pitch in hertz (Hz, vibrations per second) and how many cents it is off. A cent is a hundredth of a semitone.
The notes of the violin and the viola
Strings are listed from the lowest (the thickest) to the highest. The highest string is string 1.
| Instrument | String 4 | String 3 | String 2 | String 1 |
|---|---|---|---|---|
| Violin | G3 (196.0 Hz) | D4 (293.7 Hz) | A4 (440 Hz) | E5 (659.3 Hz) |
| Viola | C3 (130.8 Hz) | G3 (196.0 Hz) | D4 (293.7 Hz) | A4 (440 Hz) |
Each string is a fifth (7 semitones) above the one before it. The viola is a fifth lower than the violin. Its G, D and A are the same notes as the violin’s.
Tip: To remember the violin strings, say “Good Dogs Always Eat” (G D A E). For the viola, say “Cats Go Down Alleys” (C G D A).
How to tune a violin
- Tune the A first. It is the note an orchestra tunes to. Then tune D, G and E.
- Small changes: fine tuners. These are the small screws on the tailpiece. Turned clockwise, seen from above, they make the note higher.
- Bigger changes: the pegs. Turn the peg slowly, and push it gently into the pegbox as you turn. The push keeps it from slipping back.
- Check the bridge. Tuning pulls the top of the bridge towards the fingerboard. Look from the side: the bridge should stand straight up from the top of the violin.
- Check all strings again. Each string you tighten changes the others a little.
Note: The E string is thin steel. A tiny peg turn moves it a lot, and it can snap. Almost every violin has a fine tuner on the E, so use it.
If something’s wrong
A peg slips back, or won’t turn
- It slips: push the peg firmly into its hole while you turn it. Pegs slip more in dry air, when the wood shrinks.
- It sticks or jumps: turn it back a little, then forward slowly. Pegs stick more in damp air.
- If it keeps slipping or sticking, ask a violin shop. They can add peg paste, or fit the peg again.
The fine tuner won’t turn any further
- It is screwed all the way in. Look underneath: it can scratch the top of the violin.
- Turn the fine tuner back to the middle of its range.
- Tune the string with its peg, then finish with the fine tuner.
The bridge leans or has moved
Don’t play on a leaning bridge. It can fall over, and the strings can crack the top.
- Loosen the strings a little.
- Ask your teacher or a violin shop to straighten it. It is quick to fix.
The tuner doesn’t react when I play
- Check that the hint under the tuner doesn’t say the microphone is paused.
- Bow a little more firmly, and put the phone on a stand about 30 cm (a foot) away.
- Make sure the browser listens to the right microphone. Unplug a headset you don’t use.
- Try the microphone test. If it hears nothing either, the problem is the microphone.
The note jumps around
- Use long, steady bows on one string at a time. Don’t let the next string ring.
- Rosin the bow if the sound is thin or scratchy.
- Keep other sounds down: talking, music or other players.
It shows the wrong string
- Check Instrument. A violin’s E can’t be read on the viola, and the viola’s C can’t be read on the violin.
- A string that is very far out of tune can look like its neighbour. Check the string number before you turn a peg.
- A string that slipped about two notes down can show as a lower string in tune. If the string number isn’t the one you play, tighten slowly and watch the number change.
I can’t hear the string’s note
- Turn up your device’s volume.
- On iPhone or iPad, turn off Silent mode.
- While the tuner listens, an iPhone can play the note quietly. Press Stop tuner, then press the string again.
My browser blocked the microphone
The tuner shows how to allow it for your browser, with a Try again button. You can still tune by ear: press a string to hear its note.
How the violin tuner works
The tuner listens to your microphone inside your browser. It looks for the time after which the sound repeats itself: that is one vibration of the string. The method is called YIN, and it is used by many tuners and music apps.
- Readings: about 25 a second. The tuner shows the middle value of the last 5, so one stray reading never moves the needle.
- Accuracy: on a clear, steady note the reading is steady to about 1 cent. A noisy room or a scratchy bow make it wobble by a few cents.
- Range: the violin listens from C3 (131 Hz) to F♯6 (1,480 Hz). The viola listens from F2 (87 Hz) to B5 (988 Hz). Sounds outside the range are ignored.
- The browser’s clean-up is off: noise suppression, echo cancellation and automatic volume would treat a long bowed note as noise.
- Limits: the tuner checks the open strings only. It can’t tell whether your fingers are in tune, or whether the bridge or soundpost need a repair.
Questions and answers
Can I tune a viola here?
Yes. Choose Viola in Instrument. The strings change to C G D A, and the string buttons play the viola's notes.
You can also open it straight away with this link to the viola tuner.
Does it work for a small violin, such as 1/2 or 3/4 size?
Yes. Every violin size uses the same notes, G D A E. A fiddle is a violin too, so standard fiddle tuning works here. For other fiddle tunings, such as A E A E, use our online tuner, which names any note.
Should I use the pegs or the fine tuners?
Use the fine tuners when a string is only a little off. Use the peg when a string is far off, or when its fine tuner is screwed all the way in or out. Many violins have a fine tuner only on the E string. Then tune the other strings with their pegs.
My orchestra tunes to 442. Can I change it?
Yes. Set Pitch of A4 to 442 Hz. Every string moves with it. Many European orchestras use 442 or 443 Hz, and Baroque groups often use 415 Hz. Use the pitch your teacher or conductor asks for.
What are cents?
A cent is a hundredth of a semitone, the step between two neighbouring notes. The tuner says how many cents a string is too low (−) or too high (+). Within 5 cents counts as in tune, which is closer than most ears can hear.
My teacher tunes by ear, and the tuner says it is a few cents off. Who is right?
Both. Players often tune each pair of strings until they sound smooth together, a "pure" fifth. That fifth is 2 cents wider than a tuner's. So from the A, the E ends up about 2 cents high and the G about 4 cents low. The tuner calls both In tune.
Is my playing recorded or uploaded?
No. The tuner measures the sound inside your browser, on your device. Nothing is recorded, kept or sent anywhere.