Guitar tuner

Play a string and see if it is too low or too high. For guitar, bass, ukulele and violin.

The sound stays on your device. We don't record or upload it.

Your browser will ask to use your microphone. Choose Allow.

Hear a string: press it to play its note

Quick start

  1. Press Start tuner, then choose Allow.
  2. Play one string and let it ring.
  3. Turn its peg until the tuner says In tune.

How to read the tuner

The large letter is the note to tune to. With an instrument chosen, it is the open string you are playing, such as E2 for the thickest guitar string. The number after the letter is the octave.

What you see What it means What to do
Too low. Tighten the string a little. Needle left of the middle. The string sounds lower (flat) than its note. Turn the peg to tighten the string, a little at a time.
Too high. Loosen the string a little. Needle right of the middle. The string sounds higher (sharp) than its note. Loosen it a little past the note, then tighten up to it. Strings hold better that way.
In tune with a check mark. Needle in the middle. Within 5 cents of the note. Go to the next string. Its button keeps a check, so you can see which strings are done.
Much too low or Much too high More than half a semitone off. Check that you are playing the string the tuner shows.
Not an open string The note is far from every string of the tuning. Play the string without pressing a fret. Check the Tuning.

The small figures show the exact pitch in hertz (Hz, vibrations per second) and how many cents it is off. A cent is a hundredth of a semitone.

These are the notes of every tuning. Strings are listed from the thickest (lowest) to the thinnest.

Instrument Tuning Notes
Guitar Standard E2 A2 D3 G3 B3 E4 (82.4, 110, 146.8, 196, 246.9, 329.6 Hz)
Guitar Drop D D2 A2 D3 G3 B3 E4
Guitar Half step down E♭2 A♭2 D♭3 G♭3 B♭3 E♭4
Guitar Full step down (D standard) D2 G2 C3 F3 A3 D4
Guitar Drop C C2 G2 C3 F3 A3 D4
Guitar DADGAD D2 A2 D3 G3 A3 D4
Guitar Open G D2 G2 D3 G3 B3 D4
Guitar Open D D2 A2 D3 F♯3 A3 D4
Guitar Open E E2 B2 E3 G♯3 B3 E4
Guitar Open C C2 G2 C3 G3 C4 E4
Bass guitar Standard, 4 strings E1 A1 D2 G2 (41.2, 55, 73.4, 98 Hz)
Bass guitar 5 strings B0 E1 A1 D2 G2
Bass guitar 6 strings B0 E1 A1 D2 G2 C3
Bass guitar Drop D D1 A1 D2 G2
Bass guitar Half step down E♭1 A♭1 D♭2 G♭2
Ukulele Standard, high G G4 C4 E4 A4
Ukulele Low G G3 C4 E4 A4
Ukulele Baritone D3 G3 B3 E4
Ukulele D tuning A4 D4 F♯4 B4
Violin Standard G3 D4 A4 E5 (196, 293.7, 440, 659.3 Hz)

Tip: Tune every string once, then check them all again. Tightening one string pulls the neck a little, so the others move too.

New to tuning? How to tune a guitar shows each step, with a tuner and by ear. For the chords and songs of Drop D, see Drop D tuning. What each tuning is for, and how to hear it: guitar tunings.

If something’s wrong

The tuner doesn’t react when I play

  1. Check that the hint under the tuner doesn’t say the microphone is paused.
  2. Play a little louder, and hold the device closer to the instrument.
  3. Make sure the browser listens to the right microphone. Unplug a headset you don’t use.
  4. Try the microphone test. If it hears nothing either, the problem is the microphone.

The note jumps around

  1. Play one string at a time, and stop the other strings from ringing with your hand.
  2. Let the string ring. Read the tuner a moment after you pluck, not during the pluck.
  3. Keep other sounds down: talking, music or a fan.
  4. Play softer. A string hit hard sounds sharp for a moment.

It shows the wrong string

The tuner picks the string nearest to the note it hears. A string that is very far out of tune can look like its neighbour, and a microphone can hear a low string an octave too high.

  1. Check the string number under the note before you turn a peg.
  2. Choose the right Tuning.
  3. Turn the peg slowly, and check that the needle moves the way you expect.

The low strings of my bass don’t work

Some built-in microphones hear deep bass poorly, and a bass’s low E is only 41 Hz. Hold the microphone close to the bass or its amplifier. If it still jumps, play the harmonic at the 12th fret: touch the string lightly over the fret and pluck. The tuner reads it as the same string.

I can’t hear the string’s note

  1. Turn up your device’s volume.
  2. On iPhone or iPad, turn off Silent mode.
  3. While the tuner listens, an iPhone can play the note quietly. Press Stop tuner, then press the string again.

My browser blocked the microphone

The tuner shows how to allow it for your browser, with a Try again button. You can still tune by ear: press a string to hear its note.

How the guitar tuner works

The tuner listens to your microphone inside your browser. It looks for the time after which the sound repeats itself: that is one vibration of the string. The method is called YIN, and it is used by many tuners and music apps.

  • Readings: about 25 a second. The tuner shows the middle value of the last few, so one stray reading never moves the needle.
  • Accuracy: on a clear, steady string the reading is steady to about 1 cent. Background noise, a buzzing string or a far-away microphone make it wobble by a few cents.
  • Range: from a five-string bass’s low B (31 Hz) to the top of a violin. Each instrument listens only to its own range, so it isn’t fooled by other sounds.
  • The browser’s clean-up is off: noise suppression, echo cancellation and automatic volume would treat a ringing note as noise.
  • Limits: the tuner can’t tell whether your guitar plays in tune higher up the neck. That is the intonation, which a guitar technician sets.

Tuners for other instruments: the ukulele tuner, the violin tuner (also viola), the bass tuner, the cello tuner and the online tuner for any note, banjo and mandolin. Singers can find their range with the vocal range test.

Questions and answers

Does it work on a phone?

Yes. It works in the browser on iPhone, iPad and Android phones. Hold the phone close to the guitar, about a hand's width from the sound hole.

Phone microphones hear the thickest strings less well. The tuner then reads their overtones, which works for a guitar. On a bass, play the 12th-fret harmonic if the low strings jump around.

How do I tune to drop D or another tuning?

Choose it in Tuning. The strings and their notes change, and the tuner tells you which string you are playing.

You can also open a tuning straight away with a link, for example Drop D or a 5-string bass.

What are cents?

A cent is a hundredth of a semitone, the step between two frets. The tuner says how many cents a string is too low (−) or too high (+). Within 5 cents counts as in tune, which is closer than most ears can hear.

What does "Pitch of A4" mean?

Most music tunes the A above middle C to 440 Hz, and so does this tuner. Some orchestras use 442 Hz, and some players like 432 Hz. Choose another pitch only if your band or teacher asks for it. Every string then moves with it.

Can I tune by ear instead?

Yes. Press a string's button to hear its note, then tune the string until both sound the same. When they are close, you hear a slow wobble. Tune until the wobble stops. Press the button again to stop the note.

Is my playing recorded or uploaded?

No. The tuner measures the sound inside your browser, on your device. Nothing is recorded, kept or sent anywhere.

Can it tune a cello, a mandolin or my voice?

Choose Any note (chromatic) in Instrument. The tuner then shows the nearest note for any sound with a clear pitch, from a low bass B to the top of a violin.

There are also tuners made for one instrument: ukulele, violin and viola, bass, and cello. The online tuner shows any note and has banjo and mandolin. To find how low and high you can sing, use the vocal range test. They are linked at the end of "How the guitar tuner works".

Can I tune during an online guitar lesson?

Tune on your own side, before the lesson. The tuner hears your guitar directly, not through the call. If your teacher hears notes fade or cut out, turn on music mode in the call app: see music sounds bad on calls.

Guides for this test